8+ Mgb Starter Relay Problems Article
Mgb Starter Relay Problems. If there is no 'clonk' or 'click' then the problem could be the ignition. John twist explains starter circuits and demonstrates various diagnostic approachesmg
On my 1977 mgb, i replaced the battery and starter motor and when i turn the key i hear a click at the relay but no cloink at the starter. Intermittent operation can be a sign of a failing starter solenoid. This particular problem is the byproduct of an old relay and corroded or dirty contacts.
So, Be Sure To Check It Before.
However, when the starter relay is destroyed, only a part of the signal can be sent. If the click is loud and solid, then the solenoid is working. Start the ignition and listen for sounds coming from the solenoid.
It Either Sends The Entire Current, Or It Sends Nothing.
This particular problem is the byproduct of an old relay and corroded or dirty contacts. If the starter isn't turning the engine over, find the start relay, be sure the transmission is in neutral and the handbrake on, hold a finger on the side on the start. Problems that might cause your car to act like it has a bad starter solenoid can.
If There Is No 'Clonk' Or 'Click' Then The Problem Could Be The Ignition.
Intermittent operation can be a sign of a failing starter solenoid. It still doesn't turn over, what am i doing. A battery with low ampere can cause the same trouble.
Use A Jumper Wire To Ground The Solenoid To A Bolt.
On my 1977 mgb, i replaced the battery and starter motor and when i turn the key i hear a click at the relay but no cloink at the starter. If there is a loud 'clonk' and the engine doesn't turn over then either the starter solenoid or starter motor is faulty. John twist explains starter circuits and demonstrates various diagnostic approachesmg